Innovations in Pain Management, Health and Wellness

The Conclusions and Recommendations could be combined or, in long reports, presented in separate sections.

The Conclusions and Recommendations could be combined or, in long reports, presented in separate sections.

Conclusions and recommendations

If there are no recommendations to be made as a result of the project, call this section just Conclusions.

The Conclusions section sums up the important thing points of the discussion, the essential attributes of your design, or even the significant outcomes of the investigation. As its function is to round the story essay writers off of assembling your shed, it should:

  • be written to relate straight to the aims associated with project as mentioned within the Introduction
  • indicate the extent to which the aims have already been achieved
  • summarise the findings that are key outcomes or information in your report
  • acknowledge limitations and make recommendations for future work (where applicable)
  • Highlight the usefulness or significance of your work.

The conclusions should relate with the aims associated with the work:

The purpose of this project would be to design a cell phone tower for a suburban location..

The cell phone tower presented here may be erected safely in a suburban street.

It requires an overall total area of no more than 2m 2 l, and has the following safety features.

This investigation will review the volume of passengers utilizing the Monash University Clayton-Caulfield inter-campus bus in order to recommend adjustments to your service if required.

Analysis associated with the survey data obtained in this project suggests that use of the Clayton-Caulfield inter-campus bus has increased by 24% in the past five years. It is recommended that frequency be increased during peak usage.

The Conclusions section below is from a level 2 Civil Engineering Alternative Designs report presenting two designs for a an overpass bridge. Click on the coloured buttons to start to see the comments.

Conclusions

Each of the two bridge designs Lecturer’s comment:
An elegant beginning for a Conclusions follows on neatly from the preceding discussion. In this full case, moreover it indicates that the aims regarding the project have already been met. presented in this report fulfil the criteria specified in the project brief. Both designs Lecturer’s comment:
The main findings or outcomes – in this case one of the keys attributes of the designs – are then recapped. incorporate round piers on piled foundations, which are used since the soil conditions are unknown and perhaps unstable. Design 1, a straightforward i-girder that is composite, gets the advantage of being made of steel and therefore has longer spans and fewer piers.

Design 2, a super-T beam br >Design 2 Lecturer’s comment:
The importance of the end result – in this case the last recommendation – is actually stated. is therefore recommended. It provides Lecturer’s comment:
To finish off, the achievement of this project is reinforced. An overpass that is affordable superior durability, and fully meets certain requirements of this design brief.

Always address limitations and suggest how they might be overcome in future work. The below that is excerpt from the Conclusions of a study on a project investigating the consequence of pulsation on heat transfer in horizontal pipe flow.

Experimental results Lecturer’s comment:
Key conclusions drawn from the project. revealed that pulsed flow without flow reversal had no effect that is significant with steady flow. Preliminary experiments with reversed flow, however, clearly indicated increased heat transfer. It is likely due Lecturer’s comment:
Provide a explanation that is possible notable results, especially unexpected ones. to the large disturbances when you look at the boundary that is hydrodynamic if the flow changes direction. Further research Lecturer’s comment:
Recommend further research to deal with any extra work you think could be useful. is recommended to determine the maximum achievable enhancement.

It should be noted that Lecturer’s comment:
Acknowledge limitations or errors and suggest explanations solutions that are and/or. the experimental results try not to agree with the equations that are theoretical. This may be due to the deposits which developed within the pipe, or even to inconsistent thermocouple temperature. Therefore, regular inspection regarding the test rig is recommended.

For an extremely long report, it really is acceptable to present the conclusions and recommendations in point form:

The prototype robot courier presented here has been confirmed to be capable of delivering documents autonomously in an office environment. It offers demonstrated listed here components of mobile robotics:

  1. Localisation: The Kalman localisation that is filter-based achieved sub-centimeter accuracy under normal operating conditions.
  2. Environment modelling: The occupancy map was updated dynamically to include obstacles not contained in the original map.
  3. Path planning: A distance transform-based path planner using obstacle transforms produced a globally optimal local entrapment-free path to the goal.
One Comment

Leave a Reply

Your email address will not be published.